IN Floor Scraper Chain Feed Conveyor Feed Hopper consists of:
1.5m wide X 4m long and is fabricated from 5mm thick steel plate, with a capacity of 3 cubic meters.
The hopper’s bottom opening has continuous adjustable rubber flashing in contact with the 1m wide x 5m chain belt feeder.
Scraper Chain Incline Conveyor
Scraper chain conveyor is 1m wide x 9m long and is fitted with a steel slots with rib back supports.
3 ply belt is fitted 5mm top cover 1.5mm bottom cover
Rugged structural steel sub-frame incorporates chain and sprocket drive
700mm high sides to elimate spilage
Four Bay Picking Station
The horizontal picking belt is a 1000mm wide X 11.5m long and run flush with the main structure allowing material to be safely and easily disposed of to each of the 8 outlet chutes 750mm x 450mm
Bay dimensions 2.2m wide x 3m high with suitable bracing mountings on RSJ uprights
Variable speed control is mounted facing discharge side of the screen area giving the operator a full view of the material on the conveyor.
Enviro Cabin
A steel clad double skinned cabin with wall insulation to reduce noise and dust levels
Mounted the full length of the picking station complete with 4 off plastic double glazed windows.
4off access doors with plastic flaps at entrance and discharge end of picking belt
Suitable lighting is installed
Over – Band Magnet
The over band magnet is fitted on the last bay with adjustable stainless steel shackle supports.
The stainless steel chute to collect the recovered steel into a suitable container
Horizontal and inclined Scraper Chain Conveyor to supply baler
Horizontal and inclined section of the Scraper chain conveyor is 1m wide x 21m long and is fitted with steel slots with rib back supports.
700mm high sides to elimate spilage
GB 1108f 30 Hp Baler C/W Control Panel
Multi Material Baler fed by in floor feeder
Automatic Tie System
Electrical Control Panel
Fitted with sequence start up and shut down
Remote control panel in the Picking Station to control the complete system
